Industrial & Business Services

We cover everything from new build properties to the installation of a single circuit including outside sockets and lighting. If you’re in need of general alterations or require testing & inspection, then we are right at hand to help!

New Installations & Additions

Carry out full installation of units tailored to your requirements, add additional circuits to supply new equipment or alter pre-existing wiring. Vehicle charging point

Machine Installation

Whether you are moving premisses or getting new machinery we will work with you to keep down time to a minimum! This works hand in hand with our experience in looking after older machinery.

Distribution Upgrades

Some Industrial units were built over 40 years ago, which means that a lot of systems have dated Installation systems. This can be a problem for growing business needing where things are changing. We can remove and install new Switch gear to ensure the safety of the installation allowing more room to grow.

Testing and Inspection

Industrial can be challenging to Inspect due to its size and can put some people off, however there is no fear here. Does not matter how big or small we can work our way through it to get from the start to the Finish.

Machine Fault finding & Tool repair

Our knowledge of control circuits means we can get your machines going as we understand how important it is to keep the business moving forward. We already keep a wide range of machinery going through out the north east! Time is money! call out service available.

EV Charging

Helping your business keep up to date with the modern times, we can install charging units that can be used for staff or visitors. These can be metered or have a pay as you charge. Or it can just be for your own use. Plus, the BIK rate is only 1% on both new and existing Electric vehicles where the average petrol or diesel vehicle is 20-37%

Recent Industrial Projects

Replacement Distribution Board

  • Fitted Distribution board and trunking around old +temporary feeds to units.
  • Added new meters for each of the unit to be supplied.
  • Main feed split via Henley blocks to accommodate larger feed required.
  • Began removing old connections and connecting cables into the new distribution board.
  • Fitted out main unit circuits and connected to the distribution board also.
  • Fully tested

New Industrial unit

  • Discussed client requirements to allow for a fully bespoke lighting design
  • Installed sockets in preferred locations around the unit
  • Installed 200w led lights on the roof using 13a plug and socket to enable ease of change and inspection and testing
  • Outdoor floodlights mounted and connected with daylight sensors also an override switch was fitted
  • Feeds provided for both roller shutter doors and all cables connected to main distribution board

Testimonials

Very happy with the quick and tidy work provided by Yarm Electrical Services, the installer came up with some ideas for lighting I hadn’t though of. Will use from now on

M Woods

Stockton-on-Tees

Needed a new Distribution board, Chris was very professional and delivered the completed job in good time fitting around my hours of business

D Raw

Yarm

Chris talked me though lighting options for my new unit, he recommended LED to be fuel efficient and effective and they work really well. He was informative and knowledgeable

K Johnson

Carlton

Address

9 Mayfield Crescent
Eaglescliffe
Stockton-on-Tees
North Yorkshire
TS16 0NQ

Phone

07960 789 799

Email

contact-us@yarmelectrical.com

    Emergency
    Electrical Services

    If you have an electrical emergency,
    please call us immediately on
    07960 789 799